After aborting the installer if i try to install again, installer is still pointing to old path

Question

I am trying to install a installer developed using InstallShield 2008. While installing after selecting the destination path i am aborting the installation.

When i try to install again by default it is taking the destination path as previously given path which was provided before aborting the installation.

And also it is not allowing me to install in different path.

For Example:

*Step1 : Installation starts

Step2: Destination path as C:\Installer

Step3: Click next and abort installation

Step4: Start the installation again

Step5: Provide Different destination path as C:\Installer1*

Here installation is failed. Because destination is still pointing to Step2

My question is from where Installer is taking the old path.?

Answer 1

Persisted Path: The technicalities appear to be relatively straightforward: the old path is read back either from the registry or from disk each time the setup is launched, and a custom action in the setup's GUI sequence must have persisted the path "somewhere" during the first run (this is erroneous design, see technical comment below). Reading back the value can be done by using AppSearch (built-in MSI feature) or by means of a custom action.

Registry / Disk: As to finding where the value is read from. The easiest would be to just search the registry first for the literal path. Just open regedit.exe and search for the path there. You can also look for the custom action that does the persisting (or the AppSearch or custom action that does the retrieval) and see if it is a script with code you can see - then you should be able to see where it has persisted the path. Use Orca or a similar tool to view the Custom Action table. The custom action can also be compiled and undecipherable. Do you have the setup source? The path can also be persisted to disk, but the registry is most commonly used. Remember to search both HKCU and HKLM.

Involved Debugging: I can't see why you would, but it is also possible to use ProcMon.exe to monitor what registry locations your MSI reads and / or writes to. This is involved debugging and should never be needed for something this simple. Just mentioning it as a technical option. Generally the last resort we have to figure out the strangest problems.

---

Technical Comment: MSI setups are not supposed to write anything to the registry or disk from the setup's user interface sequence (setup dialogs). All changes should be made from the installation sequence (InstallExecuteSequence) which also generally runs with elevated rights - the user interface normally runs with user rights. This InstallExecuteSequence sequence is kicked off from the last dialog in the GUI sequence, and runs the file copy and system change operations. Control then returns to the GUI sequence to show the setup complete dialogs. It is also possible to run the setup silently, in which case the InstallUISequence never runs and all custom actions inserted there fail to run. Accordingly custom actions should be present in the InstallExecuteSequence as well as the InstallUISequence if they are to run in silent mode. This potential design flaw is a very common silent deployment error which occurs when setups are not designed properly for silent running. Remember that all corporate deployment runs silently. Setup GUI is highly overrated (in my opinion - a "fact" that could change in the future).

It is still possible for an MSI setup to write to the registry or disk from the InstallUISequence by using a custom action to do so. Such a custom action would normally not have access to write to HKLM or to protected parts of the disk - unless the whole setup runs elevated because it was launched from an elevated command prompt (for example), or launched by an admin who elevates it via the UAC prompt.

In other words: this setup is badly designed, but I guess that is clear already.