List Question
20 TechQA 2024-03-19T13:45:17.113000Freeze after two subsequent software resets for Zynq 7000 FPGA (with SoC)
14 views
Asked by Ahmed El Yaacoub
embedded linux buildroot how to work with axi-gpio?
38 views
Asked by Amir
BUG in HDMI showing black screen in frame difference experiment on ZYNQ platform
11 views
Asked by HY Jiang
buildroot for zedboard, how to enable axi-gpio in device tree?
49 views
Asked by Amir
Can we increase interrupt number from command prompt?
21 views
Asked by Creator
Zynq UltraScale+ zcu3eg - coresight trace
61 views
Asked by Everaldo
Why interrupts are not shown in /proc/interrupts?
77 views
Asked by Creator
Why I cannot write to registers of my zynq board?
118 views
Asked by Creator
How to trigger a software generated interrupt on core1 from core1 on bare metal?
86 views
Asked by CynFX
Under what condition I can "write" but cannot "read" from a location?
205 views
Asked by Creator
Is it possible to overload the DDR controller on Zynq through PL ? An how to analyze it?
117 views
Asked by Lucas
How can I ensure that if petalinux has configured oled drivers for me
86 views
Asked by ηεδΊ
can't access /dev/mem in a docker container
357 views
Asked by Trevor
How to check if interrupts are working or not?
352 views
Asked by Creator
How to generate inter cortexA9 interrupts based on internal timers
17 views
Asked by Dum Dum
Datasheet says EEPROM address is 0xA0 but it worked for me on 0x50. Is there a particular reason to right-shift bits?
178 views
Asked by Osama Khalid
What data type should use in software of fft vivado?
57 views
Asked by dduy_le
ZYNQ board doesn't recognized usb flash drive
116 views
Asked by Darinoos47
Vivado won't synthesize BRAM, making LUT instead
217 views
Asked by dduy_le